ORECK COMMERCIAL ORBITER FREE

Pre-mist -Wet the carpet by using Soil Realizing Pre-Spray which will mist the carpet to an area of approximately 6×6.Vacuum – Use Oreck Orbit vacuum cleaner to remove the loose dust particles on the floor.Click image to learn more Tip 5: Clean Your Dirt Carpet Use the necessary shampoo either dry or wet when cleaning.ĭifferent floors have different cleaning procedures. In case the brush is not well detached on the round pad, fix it properly. If you use the floor machine on a surface without dry shampoo or wet shampoo, it is likely to bounce. – It is either the brush or the pad holder is not appropriate in its place. If there is no source of power, check the outlet fuse and the circuit breaker. Make sure the cleaner is decisively plugged into the wall outlet. It is either you have not plugged it into the socket correctly or there is no electricity in the wall outlet. Tip 4: Avoid Common Problems that May Arise while Cleaning Your Floor Test the device when you buy it to ascertain if it is in excellent condition. It is advisable to put on shoes when using the machine. The machine’s Balanced Counter Weight System enables it to clean the floor smoothly since you can control it with fingertips. You can go over a dirt area as many times as you want until you are satisfied. The “T” handle enables you to have complete control of the machine. Tip 3: Clean the Dirt Area on Your FloorĬlench the “T” handle on the machine and glide it across the floor you want to clean in a back and forth motion. The tool should be serviced by authorized service providers or experts. Oil the bearings with light oil at the pivot points from the bondage to the housing. Orbiter machine has motor bearings that need to be periodically lubricated. Tip 2: Lubricate the Oreck Orbiter Motor Bearings Efficiently Do it politely to avoid damaging the holder pan. Lay the device on its back and pull off the brush from the round holder. If you would like to remove the brush from the machine to clean it or to replace it. Always make sure the machine motor is switched off. Make sure the brush is tightly held on the machine. Place the holder over the brush holder on the device. Lay the floor machine on its back with the handle facing on the floor.

The machine is not well fitted with the brush once you buy it. Pad spins at 1725 orbits per minute which is equivalent to 175 RPM.Conclusion Tip 1: Attach the Drive Pad Holder Properly.Oscillating motion reaches every corner right out to the baseboard.Sands, refinishes, strips, scrubs, waxes, polishes, and cleans all floor surfaces.Take a look at our other 12 inch low speed floor machines for other options. With the oscillating pad driver, the Orbiter reaches all areas of flooring, or carpeting, right up to the baseboard. They'll be clean, soft, fresh-smelling and beautiful. Vacuum up the dirt, and you can walk on your dry-cleaned carpets immediately. The Oreck electric floor buffer also works as a carpet cleaner, loosening embedded soil in the carpet for vacuuming.

ORECK COMMERCIAL ORBITER FREE

And with no belts, gears or motor brushes to wear out, it’s virtually maintenance free and one of the most reliable machines on the market today. Its oscillating motion eliminates brush marks, swirls, sanding marks and gouges. There are no special techniques to learn, and anyone who can operate a vacuum cleaner will be able to use it. Unlike other floor machines, the Orbiter is very lightweight (it only weighs 24 lbs.) and is easy to control. It strips, waxes, buffs, polishes, sands and refinishes any floor surface! The Oreck Orbiter 12 inch electric floor buffer is one of our best-selling machines because its great for light duty commercial use as well as residential home use.

Oreck commercial orbiter